Conversion To Different Gas Type - Fisher & Paykel CG603 Installation Instructions Manual

Installation Instructions
flexible connector have a temperature of less
than 70°C.
In all other countries this appliance must be
installed in accordance with local regulations
and standards.
LP gas
For flexible connections use a bayonet
type hose, suitable for use on LP Gas up
to 50mbar pressure rise. The flexible hose
should be coloured black with a red strip,
band or label. If in doubt, contact your
supplier.
Gas supply connection check
To enable the gas supply to be readily shut
off, the gas supply must be connected with
an isolating valve close to the product. After
installation and making all connections
check thoroughly for possible leaks.
1
Turn all control knobs on the unit to "off"
position.
2
Open the valve on the gas supply.
3
Using a suitable leak detection fluid solution
check each gas connection one at a time by
brushing the solution over the connection.
4
The presence of bubbles will indicate a leak.
Tighten the fitting and recheck for leaks.
Ensure the washer (supplied) is located
between elbow and manifold.
5
Turn on product control cock and light each
burner.
6
Check for a clear blue flame without yellow
tipping. If burners show any abnormalities,
check that they are located properly and in
line with injector nipple. Check correct jets
are installed.
If after following the instructions given,
satisfactory performance cannot be
obtained, contact the local gas authority
or your local Approved Service Agent for
advice and assistance.
8

Conversion to different gas type

Burners can be used with NG or LPG,
provided that the injector orifices appropriate
for the gas delivered are installed.
To change the injector orifices, you will
need a 7mm box spanner and a 10mm ring
spanner (CG913 only).
1
Turn off the main electrical supply.
WARNING!
Electrical Shock Hazard inside.
2
Ensure all gas valves are turned off.
3
Remove all trivets and burner heads.
4
Remove the 2 screws holding each burner
bowl (3 on the wok burner).
5
Lift hob tray from the product.
WARNING!
Cut Hazard - sharp edges.
6
Unscrew the orifices and replace them
with the correct ones. (size numbers are
stamped on the side, e.g.. 70= 0.70mm) (see
fig. 1).
7
Resetting the Venturi (see fig. 2):
With the product isolated from the electrical
supply, ignite the burner using a match.
The flame will probably be lifting off the
burner (see fig. 3).
Loosen the venturi securing screw. Move
the venturi towards the injector until the
flame begins to 'yellow tip' (see fig. 4).
Move the venturi back until the 'yellow
tip' just disappears (see fig. 5) - this is the
correct venturi setting. Tighten the securing
screw.
8
To replace the CG913 hob tray, repeat steps
4&5 in reverse.
9
IMPORTANT! Reset the minimum setting
(see Minimum setting or turn down).
10
After re-assembly verify the insulation
resistance and earth continuity of the
electrical circuit.
Continued...