Connecting The Wireless Subwoofer - Samsung HW-H570 User Manual

CONNECTING THE WIRELESS SUBWOOFER
The SubwoofeCs !inking ID is preset at the factor}' and the main unit and subwoofer should link
(connect wire!essty) automatically when the main unit is turned on_ If the LINK indicator does not light
when the main unit and subwoofer are turned on, pteaseset the ID by foitowing the procedure be!ow_
Comptete this processwithin 30 seconds after the Link Indicator on the subwoofer starts blinking_
I, Ptug the power cords of the main unit and subwoofer into an AC wail out!eL
2_ Confirm that the main unit is off (in STANDBYMode)_
3, Pressthe ID SETbutton on the back of the subwoofer with a sma!l, pointed obiect for 5 seconds_
. TheSTANDBY indicator is turned off and the LINKindicator (Blue LED)blinks quickly
4, While the main unit is powered off (STANDBY mode),
press MUTE on the remote controt for 5 seconds_
5o The ID SETmessage appears on the main unit's OLEDdisptay_
6, 1-ofinatize the !ink, turn the main unit's power on whi!e the
subwoofeCs LiNK LEDblink£
• The main unit and the subwoofer should now be linked
. The LINK indicator (blue LED) on the subwoofer should be turned on and solid blue
. If the LINK indicator is not solid blue, the linking process has failed Turn off the main unit and start
again from Step 2
. You can enjoy better sound from the wireless subwoofer by selecting the a Sound Effect (See page
'_ Before moving or installing the product, be sure to turn off the power and disconnect
the power cord
'_ If the main unit is powered off, the wireless subwoofer will be in the standby mode and
the STANDBY LED on the upper side will come on after the LINK indicator (Blue LED)
blinks for 30 seconds
'_ If you use a device that uses the same frequency (2 4GHz) as the unit near the unit,
interference may cause some sound interruption
'_ The transmission distance of the wireless signal between the main unit and subwoofer is
about 33 ft, but may vary depending on your operating environment If a steel-concrete
or metallic wall is between the main unit and the wireless subwoofer} the system may
not operate at all, because the wireless signal cannot penetrate metal
'_ If the main unit doesn't make a wireless connection, follow steps 1-5 above to retry the
connection between the main unit and wireless subwoofer
The wireless receiving antenna is built into the wireless subwoofer Keep the unit away
from water and moisture
For optimal listening performance, make sure that the area around the wireless
subwoofer location is clear of any obstructions
11