Ethernet Connection; Power Supply - Samsung SNF-8010VM User Manual

installation & connection

ethernet connection

Connect the Ethernet cable to the local network or to the Internet.

power Supply

Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
If both PoE and DC12V are applied simultaneously, the product will be supplied with power from
`
J
PoE.
- You can also use a router featuring PoE to supply power to the camera.
- Use PoE that is compliant with the IEEE802.3af protocols.
Be careful not to reverse the polarity when you connect the power cable.
`
If you want to connect an external device, you must turn off the external device before proceeding.
`
connecting a connector cable (Snf-8010vm)
Connect the M12 male connector into the hole of the M12 Female connector of the
camera.
This camera uses Female, D-coded types.
`
M
PoE (Power over Ethernet) is supported.
`
You are recommended to use a shielded network connector.
`
Connect this camera to a shielded network cable (STP).
`
J
Please, use 4 poles, Male, D-coded type external cables that
`
meet the M12 specification.
Check whether the PoE device is properly connected to the
`
ground.
22_ installation & connection
RX-
TX-
TX+
RX+