Table of Contents
Advertisement
installation & connection
connectinG witH otHer Device
The BNC Out terminal of the product is provided for easier installation, and is not recommended
`
J
for monitoring purposes.
If you keep the BNC cable connected, a risk of lightening may cause damage or malfunction to
the product.
ethernet connection
Connect the Ethernet cable to the local network or to the Internet.
power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
Be careful not to reverse the polarity when you connect the power cable.
`
J
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
If PoE and DC 12V are both applied, this camera will get supplied with power from PoE.
`
Please make sure the monitor and camera are turned off when connecting them.
`
16_ installation & connection
SD CARD
SD CARD
SD CARD
AUDIO OUT
VIDEO
SD SYSTEM POWER
RESET
NETWORK
1 : ALARM OUT 4 : GND
2 : ALARM IN
5 : RS-485+
3 : ALARM COM
6 : RS-485-
ACT
LINK
1 2
3 4 5 6
Ethernet
Monitor
AUDIO IN
GND
+
DC 12V
Power
Advertisement
Table of Contents
