Connect Mainboard Audio Cables - Vand A170 User Manual

III Hardware Installation
3. Place the mainboard on the
system plate, aligning the
mainboard mounting holes over
the standoffs. Make sure the
mainboard's I/O connectors are
aligned with the correct slots on
the I/O shield plate of the system
plate. Insert the mounting screws
through the mainboard mounting
holes into the standoffs and firmly
screw secure.
Caution:
Check to ensure that the underside of the mainboard is not touching the system plate in
any place. If there is any contact the mainboard may short, causing permanent damage.
Note:
Please refer to the user's manual provided by your mainboard vendor for the installation
procedure of CPU, CPU Fan / Heat sink and Memory Module.
3-3-4 Connect Mainboard Audio Cables to activate Line-out / Mic-in jack on
the rear of the system
1. Find the audio connector which
control the mainboard's audio
function. The connector
default jumpers on it.
2. Remove the jumper.
has
- 15 -