Subscribe to Our Youtube Channel
Related Manuals for iSP Technologies Bass Vector 115
Summary of Contents for iSP Technologies Bass Vector 115
- Page 2 Combining the low frequency extension that only an 15” driver can achieve with the natural, extended (but not brittle) highs of dual 8” drivers, the Bass Vector 115 cabinet achieves a balance of depth, impact, and definition that makes 4x10’s sound lifeless in comparison! Available in active and passive versions, a single active cabinet delivers 600 watts to its speakers.
- Page 3 PRECAUTIONS NOTE: IT IS VERY IMPORTANT THAT YOU READ THIS SECTION TO PROVIDE YEARS OF TROUBLE FREE USE. THIS UNIT REQUIRES CAREFUL HANDELING. All warnings on this equipment and in the operation instructions should be adhered to and all operating instructions should be followed. Do not use this equipment near water.
- Page 4 BASS VECTOR 115 CABINET BACK PANEL CONNECTIONS 1. POWER JACK This switch controls the power to the amp module. This switch has only two positions up is on and down is off. 2. POWER INLET MODULE This module provides a connection for the power cord and also houses the main fuse.
- Page 5 SPEAKON CONNECTOR This speakon connector can be found on the back panel of the Bass Vector Passive cabinets. Connect to the corresponding Neutrik speakon connector of the Bass Vector Active cabinets. FUSE REPLACEMENT 1. Use a small screwdriver as shown to slide the fuse cover out from the power inlet module.
- Page 6 BASS VECTOR 115 SPECIFICATIONS LF DRIVER: 1 X 15 inch, large excursion, 450 watt RMS. HF DRIVERS: 2 x 8 inch, high sensitivity, 250 watt RMS. SENSITIVITY: 98dB @ 100 Hz, 102dB @ 1KHz (1 watt at 1 meter. SPL: 125dB @ 1 meter, long term.
-
Page 7: Warranty And Service
Any damage resulting from the misuse or the failure to follow the precautions and instructions will void the warranty. In the event that the unit needs to be repaired, please return the unit to ISP Technologies directly. Simply repack the unit, send a copy of the original receipt, a note stating the...
Need help?
Do you have a question about the Bass Vector 115 and is the answer not in the manual?
Questions and answers