Table of Contents
Advertisement
LESS THAN 1 / 4 OF THE SUPPORT THAT.
ARE ADVISED NOT CLEAN water to send to the refrigerator so the water must first pass forced through the
filter of your aquarium.
After the installation of control that these tubes are not crushed by curves do not conform to the same bend
of the tubes. King sees the FIGURE 1, 2 and 3.
E) BEFORE YOU TURN THE CAR:
1) Check that the level into the water is sufficient.
2) Turn on the recirculating water pump and check that there are LOSSES IN CONNECTION TO COOLER.
3) VERIFY THAT THE TUBES TO SEND AND RIASALITA are properly connected (see above FIG. 1, 2 and
3).
PROGRAMMING
ACTION pumps OR THE OUTER FILTER FOR 'The aquarium water throughout the COOLER AND WAIT 3
MINUTES. TO THIS POINT
TURN THE MACHINE THROUGH A SIDE switches.
A) TEMPERATURE VALUES:
Turn on the machine and after pressing the button "SET" LED will light the "1" (mod. HC-300A - 500A -
1000A) or "2" (mod. HC-100A - 150A) and next the temperature refrigeration .
A second time by pressing the button "SET", the LED light will turn off and display the temperature of the
aquarium. The blinking indicates that the machine is ready to be programmed.
B) SETTING THE TEMPERATURE:
King pressed the button "SET" for more than 3 seconds and appear dipslay temperature refrigeration.
King pressed the button to increase the temperature or the button to decrease. King pressed the button
"SET" to confirm the desired temperature or wait 8 seconds, after which it will set
and the display automatically returns the temperature of the aquarium. The values are refrigeration 4 ° C to
28 ° C.
C) AUTOMATIC PROTECTION:
The machine is equipped with an automatic electrical protection. After the first programming inside the
compressor turns on after 3 minutes; rescheduled if the temperature returns to the compressor after 1
minute.
D) SWITCH OFF AND AUTOMATIC:
When the car reaches the temperature you set will shut off automatically when the temperature of the
aquarium will increase by one degree, the machine returns automatically. Led the "7" (mod. HC-300A-500A -
1000A) or "6" (mod. HC-100A - 150A) will appear on the display when the machine is in cooling mode and
will shut off when it reaches the temperature chilling you set.
E) CAUTION:
IN CASE OF BREACH OF PROBE OF TEMPERATURE ON display ' "P1" AND THE MACHINE IS
FERMER' AUTOMATICALLY.
DO NOT ATTEMPT TO OPEN THE REFRIGERATORE MA CONTACT A QUALIFIED TECHNICIAN FOR
THE REPLACEMENT OF THE PROBE.
CARE AND MAINTENANCE
Hide quick links:
Advertisement
Table of Contents
