Beer Keg Installation Instructions - Danby DKC052BSLDB Owner's Use And Care Manual

Beer Keg Installation Instructions

SPANNER FAUCET
WRENCH (Not Included)
PLASTIC FAUCET
LEVER
DISPENSING OF BEER
Spanner faucet wrench (not provided) is for either removing or tightening
the connection.
Attach the black plastic lever (pull handle) to the top of the faucet by
tightening it by hand clockwise until the end, holding in the silver nut
underneath so it does not turn. If there is still a small drip from the faucet,
you may have tightened the plastic lever too much and may need to
unscrew silver snug counter-clockwise (as shown) one turn.
• Keep beer keg refrigerated at all times.
• Never allow beer lines to dry out.
• Use clean beer glassware before pouring.
• Hold glass at a 45° angle when 2/3 full, start to straighten glass as the
glass fills.
• Always make sure the faucet handle is pushed all the way back.
Note: Keg sizes that can be used in your beer dispenser
1/2 barrel 59 Liters 15.5 gals
1/4 barrel 30 Liters 7.8 gals.
1/6 barrel 20 Liters 5.2 gals.
1/8 barrel 15 Liters 4.0 gals.
Note: Our Beer dispenser accepts domestic kegs up to 16-1/8" in
diameter, and up to 23-3/8" in height. Check with your distributor to make
sure keg is correct size.
11
1984 oz. 164/12-oz. Glass
992 oz. 82/12-oz. Glass
661 oz. 55/ 12-oz. Glass
496 oz. 41/ 12-oz. Glass