Cleaning And Storage - Kuchef DKE2200 Instruction Manual

Cleaning and Storage

Always switch off and unplug the appliance from the power outlet before cleaning. Also
make sure kettle has cooled down if recently in use. Wipe down the exterior of the kettle
with a moist cloth.
When storing, stow the cord beneath the base unit and make sure the lid is closed and
the kettle is correctly attached to the base. Do not store anything on top of the kettle.
Descaling/Removing Mineral Deposits
Due to using tap water, your kettle may appear discoloured inside from mineral deposits
over time. This is not rust and can be easily managed by following the below instructions.
WARNING: To prevent damage to the appliance do not use alkaline cleaning agents when
cleaning or metal scourers; use a soft cloth and mild detergents.
To remove the mineral deposits you can purchase kettle descaler products from most
leading supermarkets, department stores and hardware stores. Be sure to follow
manufacturers instructions before use.
Alternatively you can use everyday household products to clean your kettle as well.
1.
Open the Kettle lid and fill with 3 cups of white vinegar and top up with water to
maximum level. Allow to stand overnight. DO NOT BOIL.
Remove the solution, refill with fresh water and bring to the boil then discard the
2.
water. Repeat and this should remove any build ups.
Cleaning The Filter
Slide the filter out from the spout for cleaning. Take care when cleaning the filter as the
mesh can be damaged, use a soft brush or sponge to clear the mineral deposits.
WARNING: DO NOT immerse the kettle base, switch area, power base or power supply
cord in water or any other liquid.
After Sales Support
1300 663 907
customercare@winplus.com.au
Model Number DKE2200
14