Geo 1995 Prizm Owner's Manual page 81

LO: The wipers will run continuously at low speed.
HI:
The wipers will
run
continuously at high speed.
MIST:
(If you have mist-type wipers, the lever doesn't
have an
INT
position.) For a single wiping cycle, push
the lever to MIST. Hold it there for a second, then let go.
The wipers will stop after one cycle. If you want more
cycles, hold the lever at MIST longer.
Be sure to clear ice and snow from the wiper blades
before using them. If they're frozen to the windshield,
carefully loosen or thaw them. If your blades do become
damaged, get new blades or blade inserts.
Heavy snow or ice can overload your wipers. A circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
Washers
Press the button on the end of the lever to spray washer
fluid on the windshield. The spray will continue until
you release the button. The wipers will run a few times
if you have the intermittent wiper feature. If you have
the MIST feature, when you press the washer button,
washer fluid will spray your windshield and you will
need to manually turn on your wipers to clear the
windshield.
NOTICE:
When using concentrated washer fluid,
follow the manufacturer's instructions for
adding water.
Don't mix water with ready-to-use washer
fluid. Water can cause the solution
to
freeze
and damage your washer fluid tank and
other parts of the washer system. Also,
water doesn't clean as well as washer fluid.
Fill your washer fluid tank only 3/4 full
when it's very cold. This allows for
expansion, which could damage the tank if
it is completely full.
windshield washer. It can damage your paint.
Don't use radiator antifreeze in your