Geo 1995 Prizm Owner's Manual page 226

Front Sidemarker Lamps
3. Reach behind the headlamp assembly and find the
4. Turn the lock ring assembly counterclockwise.
lock ring assembly.
(It doesn't come off.)
5. Pull the bulb socket out of the housing.
6. Pull the connector apart to remove the bulb assembly.
7. Reverse the steps with a new bulb assembly.
Remember to replace the air duct if you replaced the
driver's side bulb.
Slide the outer part of the plastic clip into the hole.
Then push in the center of the clip.
1. Remove the screw near the top outside of the
headlamp assembly.
2. Remove the sidemarker assembly. There is
a snap-in
connector in the assembly, so you may have to pry
carefully on the inside edge of the assembly to
remove it.
3. Turn the bulb socket clockwise and then pull the
4. Reverse the steps with a new bulb.
bulb straight out.
6-32