Untrusted Certificate; Appendix B Use Wind River Webif To Configure The Target Device (Optional) - Intel DK100 Series Getting Started Manual

Iot gateway development kit

Hide thumbs

Table Of Contents

Table of Contents

Use Wind River WebIF to Configure the Target Device (Optional)—Intel IoT Gateway

Development Kit DK100 Series

Appendix B Use Wind River WebIF to Configure the Target

Device (Optional)

This appendix guides you through using the Wind River WebIF application. WebIF is a

web-based interface used to manage wired, wireless, and 3G connectivity on

Intelligent Device Platform XT Target Devices.

How to use WebIF

1. On the Host System, open an internet browser.

2. Choose the correct path:

Note: Be sure to use

•

If you used a wireless network connection from your Host System to your

Target Device, type the following URL into the internet browser on your Host

System:

•

If you used a wired network connection from your Host System to your

Target Device, type the following URL into the internet browser on your Host

System:

<TARGET_DEVICE_IP_ADDRESS>

Note: The Host System and the Target Device must be on the same subnet.

3. Most browsers present a pop-up warning box stating that the security certificate is

not recognized. Select the option to tell the browser to disregard the certificate

and connect to the Web site. In the following example, you would click I

Understand the Risks, and then Add Exception:

Figure 31.