Creek Audio 5250 Operating Instructions

Thank you for purchasing the 5250 amplifier You are now in possession of a State of the Art
Integrated Amplifier The functions and operation of the 5250 and Special Edition are exactly the
same and are very simple However the following notes are provided to explain all aspects of its
design and use
Operating Instructions

MAINS CONNECTION

When unpacking the amplifier please keep the packing material
in a safe place for possible future use In the pack there is a
separate mains cable suitable for connecting to the mains supply
in the country of use The IEC socket end of the cable should be
firmly inserted into the connector on the rear panel marked
"Mains Input'
Remember do not overload the mains wall socket with too many
plugs or adaptors The high quality performance of the amplifier
will be impaired if the electrical supply to it is in poor condition If
in doubt consult a qualified electrician or your dealer
The Mains Input' connection is also fitted with a fuse specifically
suited to the supply voltage of the country of use The correct
value is clearly marked on the rear panel next to the Mains Input
Should it be necessary to replace the fuse ensure that you
use the same type as specified on the rear panel i e
5 x 20mm cartridge type: T 3.15 A surge resisting for
220-240V 50Hz AC, T 6 3 A surge resisting for 110-
120V 60Hz AC or an T 8A surge resisting for 100V
(Japan)