Miele DG 4164 Operating Instructions Manual page 53

... After switching on, the descaling
programme symbol k and 00 appear
in the programme/temperature
display, the k symbol also appears
on the left of the display, and the
appliance beeps.
The appliance needs to be descaled.
Proceed as described in "Descaling" in
"Cleaning and care".
... k and E04 appear in the
programme/temperature display and
0:06 appears in the time display.
The descaling process was interrupted
by a power cut or by being
inadvertently switched off.
The appliance will automatically carry
out a rinsing programme after being
switched on again to flush out any
descaling fluid. This process cannot be
aborted. Wait until you hear several
beeps, and the g symbol is flashing in
the time display. Now you can either
re-start the descaling process, or select
another programme.
Problem solving guide
... the following fault messages
appear in the
programme/temperature display.
For all fault messages:
The door can only be opened when:
- the fault message is flashing
alternately with the set
temperature,
the g symbol is flashing in the
-
time display,
- the alarm has stopped.
If the display is not flashing, the
appliance is still processing the
fault.
F06 The temperature thermostat is
faulty.
Switch the appliance off and call the
Service Department.
F12 p Water is not getting into the
appliance.
Check whether
– the stopcock is open. If necessary
open it and start the programme
again.
– the water inlet hose is faulty.
– the filter in the water inlet is blocked.
If you cannot remedy the fault yourself,
switch the appliance off and call a
plumber or the Service Department.
53