Table of Contents
Advertisement
Quick Links
Compu-Video Systems Inc.
V V
V
C
Thank you for purchasing one of our products. Please read this manual before using the this product.
When using this product, always follow the instructions contained in this manual, and pay close
attention to the safety information.
P.O. Box 749 Peekskill, NY 10566
S
The CTS Series
CTS-2
CTS-16
TEL: (845)737-7009
Instruction Manual
CTS-4
CLS-4
Fax: (845)737-0426
CTS-8
CLS-8
Web: www.compuvideosystems.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CVS CTS-2
Summary of Contents for CVS CTS-2
- Page 1 Compu-Video Systems Inc. Instruction Manual The CTS Series CTS-2 CTS-4 CTS-8 CTS-16 CLS-4 CLS-8 CLTS-4 CLTS-8 Thank you for purchasing one of our products. Please read this manual before using the this product. When using this product, always follow the instructions contained in this manual, and pay close attention to the safety information.
- Page 2 WARNING! Do not expose this product to water, rain or moisture. Doing this can result in electric shock or fire. Never take this product apart or try to modify it. Doing so is very dangerous and could result in electric shock. Do not store this product near open flame.
-
Page 3: System Connections
5) HOME; Will freeze the scan to the selected position. If more than one position is selected, the higher number will be activated. CTS-2: 2x1 Terminating Video only sequential switcher CTS-4: 4x1 Terminating Video only sequential switcher CLS-4: 4x1 Looping Video only sequential switcher... - Page 4 Terminating/Looping Switchers: The CLTS-4 and CLTS-8 Looping/Terminating switchers are supplied with removable termination’s. To activate the loop-thru feature you must: First, disconnect the power and then remove the cover with the two side screws. CLTS-4 At the rear of the upper row of BNC connectors you will see two resistors soldered together as shown in figure below.
- Page 5 CLTS-8 To remove the termination from an input to the CLTS-8 sequential switcher please take the following steps: 1) Determine the input to be unterminated by using the diagram in figure 1. 2) Cut the 75 ohm resistor on both sides and remove it. If more than one input is to be unterminated cut the additional resistors out.
- Page 6 Notes: _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ P.O. Box 749 Peekskill, NY 10566 TEL: (845)737-7009 Fax: (845)737-0426 Web: www.compuvideosystems.com...
-
Page 7: Limited Warranty
Inc. to the user is free of charge. How To Get Service Please contact CVS by phone for return authorization number and then return the defective unit, transportation prepaid and a dated proof of purchase to: Compu-Video Systems Inc. - Page 8 Have A Video Picture Problem? Give Us A Call At (845) 737-7009 For Free Tech Support. We May Have The Answer You Are Looking For. Compu-Video Systems Inc.
Need help?
Do you have a question about the CTS-2 and is the answer not in the manual?
Questions and answers