Charging Procedure; Charging The Battery - Worx WG800 Manual

BEfORE uSING yOuR
SHEAR
Your product battery is UNcHARGED and you
must charge once before using it for the first
time.

CHARGING pROCEDuRE

1. charging thE battErY

The battery charger supplied matches to the
Li-ion battery installed in the machine. Do not
use other battery chargers.
The Li-ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit: the blade no longer move.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
2. charging (sEE a)
Plug charger plug into a suitable power outlet
and afterwards plug your tool into the battery
charger, the charging indicator (red) will
illuminate at this time.
The charger indicator will turn into green
when charging is complete, then unplug the
charging plug from the wall socket and then
remove the tool from the battery charger.
iMPortant: During the charging
procedure, the handle of the machine warms
up. This is normal.
When not using for extended periods,
disconnect the battery charger from the
socket.
Do not use the machine during the charging
procedure.
ASSEmBLy
1. ExtEnsion handlE (wg800.2)
fitting extension handle (see b,c)
Align the grooves on the machine with fixing
on the wheel cart (b).
Plug in the handle connector (a) .
removing extension handle (see c)
To release machine from wheel cart (b), pull
the machine in the direction shown.
3.6V cordless shrub shear and edging shear
adjusting handle length (see d)
1 Loosen the adjustment collar.
2 Pull the shaft out to increase the height, or
push the shaft in to decrease the height.
3 Re-tighten adjustment collar.
2. adjusting thE whEEl
hEight(wg800.2)
The tool has two wheel height positions for
adjustment.(See E1,E2)
Follow the schedules(See F1,F2):
1)Pull the right wheel outwards and hold it.
2)Turn the wheel 90° .
3)Release the wheel until it locked in the slot.
3. adjusting for Edging
ModE(wg800.2)
For edging mode, you need adjust the wheel
height to lower position(See E2) .
Turn the machine 90°, in either direction to
position the machine in the vertical edging
mode. (See G)
4. swivEling thE handlE for
coMPact shEar (wg800.2)
You could use your tool for cutting grass in
compact and limited room by swiveling the
extension handle. (See H)
In the normal operating position, align the
locking sign " " on the knob (10) with the
triangle " ", the extension handle is locked.
Rotate the handle adjust knob, adjust the
unlocking sign " " pointing to the triangle,
make sure the knob is fixed , then the
extension handle can be swiveled free.(See
I1,I2)
5. fitting/changing thE bladE
warning! wear gloves when
changing the blade.
removing
Press the tool-free blade cover release button
(5).
Remove away from the housing. (See J1)
Lift the blade out. (See J2)
fitting
Fit the blade as shown aligning the holes in the
blade onto the drive pins. (See K1)
Press the blade cover back to the housing.
(See K2)
11 11
EN