Battery Replacement - Pride Mobility Quantum 600 Sport Owner's Manual

V I I .
LUG NUTS
Figure 25. Quantum 600 Sport Drive Wheel
Follow these easy steps for a quick and safe repair for both pneumatic and solid tyres:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tyre, completely deflate it before removing the wheel.
4. Remove the five (5) lug nuts from the wheel hub. See figure 25.
5. Pull the wheel off of the hub.
6. Remove the screws and separate the front and rear rim. See figure 26.
7. Remove the old tube from the pneumatic tyre and replace it with a new tube or replace the entire assembly if it is a solid tyre.
8. Screw together the two rim halves.
9. Slide the wheel back onto the hub.
10. Reinstall the five (5) lug nuts onto the wheel hub and tighten.
11. Inflate pneumatic tyres to the psi/bar/kPa air pressure rating indicated on each tyre.
12. Remove the power chair from the blocks.

Battery Replacement

A battery wiring diagram is printed on a decal located the power base. See VI. "Batteries and Charging" for correct
battery specifications.
36
C A R E A N D
WHEEL HUB
WARNING! Battery posts, terminals and related accessories contain lead and lead
compounds. Wear goggles and gloves when handling batteries and wash hands after
handling.
WARNING! The batteries in your power chair should only be serviced or replaced by a
Quantum Rehab Dealer or a qualified technician.
WARNING! Do not replace batteries when seat is occupied.
WARNING! Power chair batteries are heavy. See specifications table. If you are unable
to lift that much weight, be sure to get help. Use proper lifting techniques and avoid
lifting beyond your capacity.
WARNING! Do not mix old and new batteries. Always replace both batteries at the
same time.
www.pridemobility.com
M A I N T E N A N C E
TUBE
FRONT RIM HALF
Figure 26. Quantum 600 Sport Drive Wheel Disassembled
TYRE
REAR RIM HALF
WARNING! Completely
deflate the tyre before
attempting repair.
Quantum 600 Sport
SCREWS