Battery Replacement - Pride Mobility jazzy 1143 Owner's Manual

V I I . C A R E
6. Use a socket spanner to remove the bolts that fasten the two wheel halves together.
7. Remove the old tube from the pneumatic tyre and replace it with a new tube.
8. Use a socket spanner to reinstall the bolts that fasten the two wheel halves together.
9. Slide the wheel back onto the shaft.
10. Reinstall the drive wheel nut into the center hub and tighten.
11. Inflate the pneumatic tyre to 2 – 2.4 bar (30 – 35 psi).

BATTERY REPLACEMENT

A diagram is printed on a decal located on the Jazzy frame near the battery tray.
WARNING! Battery posts, terminals, and related accessories contain lead and lead com-
pounds. Wear goggles and gloves when handling batteries and wash hands after handling.
WARNING! Pride Power Chair batteries are heavy. See specifications table. If you are
unable to lift that much weight, be sure to get help. Lifting beyond your capacity can
result in personal injury.
To replace the batteries:
1. Turn the power off.
2. Make sure that the Jazzy is in drive mode. See III. “Your Power Chair.”
3. Remove the seat.
4. Remove the shroud.
5. Disconnect the batteries from the electronics tray.
6. Disconnect the wiring harnesses from the batteries.
7. Install the wiring harnesses on new batteries.
8. Connect the wire marked (+) to the positive (red) battery terminal.
9. Connect the wire marked (-) to the negative (black) battery terminal.
10. Repeat 9 and 10 for the other battery.
WARNING! Make sure you tighten the fasteners so that the connections are secure.
11. Place the batteries in the power base. Make sure that the terminals are facing the correct direction. See figure 18.
12. Reconnect the wiring harnesses to the power base.
AUS Jazzy 1143/RevF/Apr03
A N D
Figure 18. Battery Wiring Diagram
M A I N T E N A N C E
www.pridemobility.com 35