Table of Contents
Advertisement
PART TWO: SAFETY INSTRUCTIONS
RASPBERRY PI REGULATORY
COMPLIANCE AND SAFETY INFORMATION
IMPORTANT: PLEASE RETAIN THIS
INFORMATION FOR FUTURE REFERENCE
GETTING STARTED
For full set up and installation instructions please visit
http://www.raspberrypi.org/qsg
WARNINGS
This product shall only be connected to an external power supply rated
■ ■
at 5V dc, and a minimum current of 600-1800mA. Any external power
supply used with the Raspberry Pi shall comply with relevant regulations
and standards applicable in the country of intended use.
This product should be operated in a well ventilated environment and, if
■ ■
used inside a case, the case should not be covered.
This product should be placed on a stable, flat, non-conductive surface in
■ ■
use and should not be contacted by conductive items.
The connection of incompatible devices to the GPIO connector may affect
■ ■
compliance or result in damage to the unit and invalidate the warranty.
All peripherals used with the Raspberry Pi should comply with relevant
■ ■
standards for the country of use and be marked accordingly to ensure
that safety and performance requirements are met. These articles include
but are not limited to keyboards, monitors, and mice used in conjunction
with the Raspberry Pi.
Where peripherals are connected that do not include the cable or
■ ■
connector, the cable or connector used must offer adequate insulation
and operation in order that the requirements of the relevant performance
and safety requirements are met.
8
Advertisement
Table of Contents
