Flying The Quadcopter - Protocol Movie-Drone Pilot's Handbook Manual

Radio controlled quad-copter with camera
Table of Contents

Advertisement

FLYING THE QUADCOPTER

Step 1: Connect the wires
on the quad-copter.
NOTE
1. If the Movie-Drone and the remote do not sync after following the checklist, reverse steps
1 and 2 of the process. Turn the remote off and unplug the cable from the Movie-Drone.
Then, turn on the remote first and then plug the cable back into the Movie-Drone to turn it
on. Follow with Step 3.
2. Turn on the controller; if, after 30 seconds, it has not recognized the helicopter, turn off the
controller to retry synchronization.
3. If quad-copter's LED blinks slowly, it means that it has not recognized the controller; please
restart pre-flight procedure.
4. If the Movie-Drone is unsteady in flight, it may not have been able to calibrate horizontally.
Power down both vehicle and remote and restart pre-flight procedure.
Step 2: Push the ON/OFF
power switch up.
Step 3: Push the throttle lever to the highest position, and
then pull it back to the lowest position. The transmitter
will beep twice. This shows that the quad-copter has synced
with the remote.
Tips: When syncing your quad-copter keep it
in a horizontal position for stable flight.
3

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Movie-Drone and is the answer not in the manual?

Table of Contents