Monte Carlo Fan Company 5vsr44XXd-l series Owner's Manual page 4

19
Remove 2 cardboards pre-installed
into the fan body. Install blades to
motor using the motor screws pro-
vided. Tighten screws and washers
by using the hex-nut driver provided.
21
Install the no light cover by using the
3 hex nut screws provided.
Use the hex nut driver to tighten the
3 hex nut screws.
24
Loosen 2 screws and remove 1 screw
from the light kit plate, save the
screw removed for later use.
27
Remove the finial cap, hex nut, and
rubber pad from the fitter.
For installation with
light kit, go to step
22.
For installation
without light kit, go
to step 20.
22
Loosen the 2 screws and remove 1
screw from the motor. Save the
removed screw for later use.
25
Connect white wire from fan to white
wire from light fixture. Then plug
blue wire from fan to black wire from
light fixture by pushing together the
connectors.
28
Install 2 x60 watt Candelabra base
bulbs. Bulbs included.
warnInG:
Over lamping the fan will
result in the fan lights shutting
down until the proper wattage
of bulbs are installed. reset the
lights by turning off the wall
switch, breaker,or by remote.
replace bulbs with the correct
wattage bulbs, turn the power on.
20
Remove 3 screws from the motor.
Save the removed screws for later
use with light kit.
23
Install the light kit plate to the motor
by twisting clockwise and install the
screw removed from step 22 to the
light kit plate. Tighten the 3 screws
securely.
26
Install the fitter to the light kit plate
by twisting clockwise, add 1 screw
removed from step 24 and tighten
the screws securely.
29
Place the glass onto the fitter as
shown.