Table of Contents
Advertisement
Starting a wash cycle...
1
Draw out the lower and upper basket, load the dishes and push them back. It is recommended to load
the lower basket rst, than the upper one (see the section entitled "Loading the Dishwasher").
2
Pour in the detergent (see the section entitled "Detergent and Rinse Aid")
3
Switch on the Dishwasher by pressing the ON/OFF button.
Make sure that the water supply is turned on to full pressure.
4
follows direction
Normal->Eco->Rinse->Glass->Rapid->Intensive;
When turning the program knob in counterclockwise direction the program
will change as follows direction
Normal-> Intensive-> Rapid-> Glass->Rinse-> Eco,
When a program is selected , the response light will light . Then press the
start/reset button, the program is running.
PREMISE:
You can modify the washing program, only if the dishwasher has been running for a short time.
may have already been released, and the appliance may have already drained the wash water. If this is the case,
the detergent dispenser must be refilled (see the section entitled " Loading the Detergent " ).
Press start/reset button more than three seconds the machine will be in stand by state ,then you can change
the program to the desired cycle setting (see the section entitled " Starting a wash cycle. . .
NOTE: If you open the door when washing, the machine will pause. When you close the door and press the
start/reset Button, the machine will keep on working after 10 seconds.
The program lights shows the state of the dishwasher:
A) One of the program lights on
B) One of the program lights blinking
C) some of the left three program lights fast blinking-->error
A forgotten dish can be added at any time before the detergent cup opens.
1
Open the door a little to stop the washing.
2
After the spray arms stop working, you can open the door
completely.
When the working cycle has finished, the buzzer o f the dishwasher will sound for 8 seconds, the n stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwash er to avoid ha ndling the dishes and utensils while they
are still hot and more susceptible to break age. They will also d ry better.
Switch Off the Dishwasher
The buzzer of the dishwasher beeps 8 seconds, only if the washing programme ended.
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down arou nd 15 minutes
before removing from the appliance.
Open the dish was her's door, leave it ajar and wait a few minutes before removing the dis hes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwashe r is wet insid e.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Bas ket onto
the dishes in the lower one.
--> stand by or pause
--> run
It is dangerous to open the door when washing, because hot water or steam may scald you.
3
Load the forgotten dishes.
4
Close the door, the dishwasher will start running again
after 10 seconds.
as
Otherwise,
the detergent
Advertisement
Table of Contents
