Oil Sensor (Option); Disassembly And Assembly; Preparation And Precautions - Robin R1300 Service Manual

9-6 OIL SENSOR (OPTION)
1. Disconnect two (2) wires comming from the
sensor at the connection.
2. Loosen the sensor to remove it from the engine.
3. Plug the opening of oil filler hole (created after
sensor is removed) with suitable means such as
oil gauge.
4. Connect the removed wires again with the oil
sensor.
5. Start the engine with the oil sensor removed and
confirm if;
OIL SENSOR
/ /
Fig.
9-9
a. Engine stops after 5 seconds which is normal, or
b. Engine does not.stop after more than 10 seconds which is unusual.
NOTE : The sensor will not operate properly when wire
i s
broken or poorly connected.
Check the wires for correct connection.
If it fails to stop within
5
seconds after the wirings have checked, the sensor is wrong.
Replace the sensor with new one.
10. DISASSEMBLY AND ASSEMBLY
10-1 PREPARATION and PRECAUTIONS
1) Be sure to memorize the location of individual parts when disassembling the generator so that the
generator can be reassembled correctly. Tag the disassembled part with the necessary information to
facilitate easier and smoother reassembling.
2) For more convenience, divide the parts into several groups and store them in boxes.
3)
To prevent bolts and nuts from being misplaced or installed incorrectly, place them temporarily back
at their original position.
4) Handle disassembled parts with care; clean them before reassembly using a neutral cleaning fluid.
5) Use all disassembly /assembly tools properly, and use the proper tool for each specific job.
-
32 -