Pride PATHRIDER ES10 Owner's Manual page 33

V I . C O M F O R T A D J U S T M E N T S
POSITIONING BELT
Your scooter seat may be equipped with an auto-type
positioning belt that can be adjusted for operator
comfort. See figure 21. The positioning belt is
designed to help support the operator so that he or she
does not slide down or forward in the seat. The
positioning belt is not designed for use as a
restraining device.
WARNING!
should be secured at all times. Never
allow the positioning belt to hang or
drag on the floor as it may become
entangled.
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the
bottom of the seat base. See figure 22.
3. Use a spanner to remove the two rear bolts on the
outermost part of the seat frame.
4. Insert the bolt through the appropriate ends of the
positioning belt and then reinstall the bolts back
into the seat frame.
5. Tighten the bolts.
To adjust the positioning belt for operator comfort:
1. Insert the metal tab on the right side of the belt
into the plastic housing on the opposite strap until
you hear a "click." See figure 21.
2. Pull the strap on the right side of the belt until it is
secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic
housing.
MANDATORY!
positioning belt is properly secured
to the scooter and is adjusted for
operator comfort before each use.
MANDATORY!
positioning belt for loose or damaged
parts before each use of the scooter.
If you discover a problem, contact
your authorised Pride Provider for
maintenance and repair.
33
The positioning belt
Make sure the
Inspect the
www.pridemobility.com
Figure 21. Positioning Belt
REAR BOLTS
Figure 22. Positioning Belt Bolts
Pathrider ES10