NEC MultiSync P750 User Manual page 15

E - 10
To attach the MultiSync P750 monitor to your system, follow these
instructions:
1. Turn off the power to your computer and MultiSync monitor.
2. If necessary, install the display card. For more information,
refer to the display card manual.
3. Make sure the BNC/D-SUB Switch on the front of the
monitor is set to the D-SUB down (pushed in) position.
4. For the PC: Connect the 15-pin mini D-SUB end of the
MultiCable to the connector of the Display card of you
system. Connect the 15-pin D-SUB end of the MultiCable to
the monitor.
For the Mac: Connect the 15-pin D-SUB end of the
MultiCable to the connector of the Display card. Connect the
15-pin mini D-SUB end of the MultiCable to the monitor.
5. Connect one end of the power cable to the MultiSync P750
monitor and the other end to the power outlet.
6. Turn on your MultiSync monitor and computer.
7. This completes the installation.
NOTE: If you have any problems, please refer to the
Troubleshooting section of this manual.
Connection to computers or Cards Using BNC Cables
The MultiSync P750 colour monitor also complements high resolution
graphics cards or systems. To attach the monitor to your system, follows
the instruction below.
1. Turn off the power to the monitor and computer.
2. If necessary, install the video card. For more information,
refer to the manual accompanying the card.
3. Make sure the BNC/D-SUB Switch on the front of the
monitor is set to the BNC up (raised) position.
Connection to Your Personal Computer