BMW 2014 X1 Owner's Manual page 254

Mobility
H7 bulb, 55 watt
1. Switch off the lamps and take the remote
control out of the ignition lock.
2. Low beam: open the folding cover in the
wheel arch, refer to page 249.
3. Remove the corresponding cover, refer to
page 249.
4. Unplug the connector from the bulb.
5. Slide the wire bracket sideways out of the
anchor, arrow 1, and fold down, arrow 2.
6. Remove the bulb.
7. Insert the new bulb.
8. Fold up the wire bracket and lock it.
9. Mount the connector.
10. Reattach the cover.
11. Low beam: attach the folding cover in the
wheel arch.
Parking and roadside parking lamps
5-watt bulb, W5W
1. Switch off the lamps and take the remote
control out of the ignition lock.
2. Remove the high beam cover, refer to
page 249.
250
Replacing components
Online Edition for Part no. 01 40 2 957 353 - X/14
3. Pull out the bulb socket, see arrow.
4. Pull off the bulb and replace it.
5. Insert the bulb socket.
6. Reattach the cover.
Xenon headlamps
Xenon headlamps
At a glance
1 Parking lamps / daytime running lights
2 Low beams/high beams/headlamp flasher
3 Turn signal
Because of the long life of these bulbs, the
likelihood of failure is very low. Switching the
lamps on and off frequently shortens their life.
Do not perform work/bulb replacement
on xenon headlamps
Have any work on the xenon lighting system,
including bulb replacement, performed only by
a service center.
Due to the high voltage present in the system,
there is the danger of fatal injuries if work is
carried out improperly.◀
I n f o r ma t i o n P r o v i d e d b y :