BMW 2014 X1 Owner's Manual page 253

Headlight setting
Changing the bulbs and lights may influence
the headlight settings. Have the headlight set‐
ting checked by a service center and corrected
if necessary after changing bulbs or lights.
Removing the headlamp cover
The high beam bulbs can be replaced via the
engine compartment, and the low beam and
turn signal bulbs can be replaced via a folding
cover in the wheel arch.
1 High beam cover
2 Low beam cover
3 Turn signal bulb socket
To remove the covers:
▷ High beams: fold out the bracket, arrow 4,
and take the cover out of the guide.
▷ Low beams: unscrew the cover, arrow 5.
Attach the covers carefully
When attaching the covers, proceed
carefully; otherwise, leaks may occur, causing
damage to the headlamp system.◀
Proceed in reverse order when attaching the
covers.
Access via the wheel arch
For low beams and turn signals only:
1. Turn the wheel inward.
2. Open the folding cover in the wheel arch.
To open the locks, turn them counter‐
I n f o r ma t i o n P r o v i d e d b y :
Online Edition for Part no. 01 40 2 957 353 - X/14
Replacing components
clockwise all the way using a coin, for ex‐
ample.
Halogen headlamps
At a glance
1 High beams/headlamp flasher
2 Parking lamps
3 Low beams
4 Turn signal
Low beams and high beams
Wear protective goggles and gloves
Halogen bulbs are pressurized. There‐
fore, wear protective goggles and gloves. Oth‐
erwise, there is a danger of injuries if the bulb
is accidentally damaged during replacement.◀
The low beams and high beams have separate
covers.
Mobility
249