Table of Contents
Advertisement
The controller must only
be installed in dry and
non-explosive areas. Mounting
the controller on an inflammable
surface is prohibited
Prior to switching on or
commissioning the device:
make sure to close the cover until
both sides securely lock into
place!
4
3
Mounting the device
3.1 Opening the device
Before opening the device, disconnect mains power and ensure that it cannot be
switched back on! The upper part of the housing is locked to the lower part using
two latches. Release the housing cover by pulling the sides outwards (see picture)
to unlatch it, and then pivot the cover upwards until it "clicks" open
3.2 Wall mounting
The device is mounted on the points marked. A drilling template is provided with
a device. Insert the "Quick Info" card provided with the device into the correspond-
ing pocket on the back of the device. The "Quick Info" card rapidly familiarises users
with the device.
Hide quick links:
Advertisement
Table of Contents
