Test Functions - Hypertech ICON 8 User Manual

Test Functions

Notes:
1. Test your system regularly and this will keep you familiar with the
system and confident in the system operation.
2. Maximum testing time is 10 minutes.
3. The system must be in OFF mode before entering test mode.
4. Test mode may not be entered until all alarm messages have been
transmitted.
5. Some panels do not have all the test modes described below.
Test 1 - Walk test - Beeper operates and section light operates.
This test enables the user to walk around and activate sensors
and check correct operation of sensors.
Test 2 - Siren test - Siren sounds for 3 seconds.
Test 3 - Strobe test - Strobe operates unitl next key press.
Test 4 - All lights and beeper operate until next key press - used to
check operation of lights and beeper.
Test 5 - Recall Last Alarm - last alarm flashes until next key press.
Test 6 - Reset Smoke Detectors (if fitted) - removes power from
the smoke detectors for 5 seconds .
Test 9 -Start a Test Report on Dialler (if fitted) - sends a test report
to the Central station and synchronises the time for next
test report. (Account number, and phone number must
be programmed for this test to start.)
Key Sequence
1 2
1
2
Off
3 4 test
page 10
Operation
Example shows a User Code 1 2 3 4
being used to enter test mode.
Test 1 started - walk test
Test 2 started - siren test
Exit test mode.