Before Installation - Miele FN 35402 i Operating And Installation Instructions

– The ventilation cross-sections in the
plinth, housing unit and above the
appliance must amount to at least
2
200 cm to ensure that air can
circulate without hindrance.
– The larger the ventilation
cross-sections, the more energy
efficient the appliance operates.
The air inlet and outlet must not be
covered or blocked in any way.
They should be dusted on a regular
basis.
Top ventilation cross-section
The top ventilation cross-section can be
achieved in various ways:
a Directly above the appliance with a
ventilation grille (free passage of at
2
least 200 cm ).
b Between furniture units and the
ceiling.
c In an intermediate ceiling.
Installation advice

Before installation

^ Before installation, remove the
accessories bag containing
installation components and
accessories from the appliance, and
remove the sealing strip from the
appliance door.
^ Do not remove the following from the
rear of the appliance:
– The spacers (depending on model).
These ensure the gap required
between the back of the appliance
and the wall is maintained.
– The bags (depending on model)
located inside the metal grille (heat
exchanger).
These are important for the correct
functioning of the appliance. Their
contents are non-toxic and are not
dangerous.
^ Remove any cable clips from the
back of the appliance.
^ Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
59