Table of Contents
Advertisement
2.7
Installing a DIMM
The system motherboard comes with two Double Data Rate (DDR) Dual
Inline Memory Module (DIMM) sockets.
The following figure illustrates the location of the sockets:
184-pin DDR DIMM sockets
2.7.1
2.7.1
2.7.1
Memory configurations
Memory configurations
Memory configurations
2.7.1
2.7.1
Memory configurations
Memory configurations
You may install up to 2 GB system memory using 256 MB, 512 MB, and
1 GB DDR DIMMs.
•
•
•
•
•
2 - 8
2 - 8
2 - 8
2 - 8
2 - 8
®
Installing DDR DIMMS other than the recommended configurations
may cause memory sizing error or system boot failure. Use any of
the recommended configurations in the table on the next page.
i d e n t i c a l
i d e n t i c a l
Install only i d e n t i c a l
i d e n t i c a l (the same type and size) DDR DIMM in
i d e n t i c a l
DIMM_A and DIMM_B.
Always install DIMMs with the same CAS latency. For optimum
compatibility, we recommend that you obtain memory modules from
the same vendor.
Due to chipset resource allocation, the system may detect less than
2 GB system memory when you installed two 1 GB DDR memory.
If you installed two 400 MHz DDR memory modules, the memory
frequency downgrades to 333 MHz.
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
C h a p t e r 2 : B a s i c i n s t a l l a t i o n
Advertisement
Table of Contents
