Record; Record Config - Security Tronix ST-DVR4CH User Manual

4.2 Record

4.2.1 Record Config.

Set the recording parameters in the surveillance channel. The system is
set 24 hours consecutive recording in the first startup. You can enter [main
menu]> [recording function]> [recording setup] to set.
Note：There is at least one read-write hard disk.<refer to chapter 4.5.1>
【 Channel 】 Choose the corresponding channel number to set the
channel. Choose the all option to set the entire channels.
【Redundancy】Choose the redundancy function option to implement
the file double backup function. Double backup is writing the video files in two
hard disks. When you do the double backup, make sure that there are two
hard disks installed. One is read-write disk and the other is redundant disk.
(Refer to 4.5.1)
【Length】Set the time length of each video file. 60minutes is default
value.
【Prerecord】Record 1-30 seconds before the
action. (Time length is decided by the code stream)
【Record mode】Set video state: Schedule manual or stop. Schedule:
Record according to the set video type (common,
detection and alarm) and time section.
Manual: Click the button and the according channel is recording
no matter the channel in any state.
Stop: Click the stop button and the according channel stops
recording no matter the channel in any state.
【Period】Set the time section of common recording, The recording will
Picture 4.1 Record Config
Page 29