Tool Shop 240-2081 Operator's Manual page 8

MAINTENANCE MAINTENANCE
REPLACING SAW BLADE
1. When replacing the saw blade,make
sure the new saw blade has a diameter
of 10", RPM rating of at least 7,000
and arbor hole of 5/8" diameter.
2. When mounting the new saw blade,
the direction arrows on the blade
correspond with the arrow on the upper
guard(See Figure 5).
3. Place the saw in its upper position.
Use supplied combination Allen Wrench & Phillips
4.
screwdriver to remove the Hex screw (2) and Phillips
screw(1) (See Figure 5).
5. Rotate the lower blade guard out of the
way(See figure 6).
6. Press and hold the spindle-lock button,
and rotate the blade at the same time
until it locks into position.
Use supplied Allen wrench to take
out the blade bolt (See Figure 7).
Caution: This is a reverse threaded screw.
If you turn the screw clockwise, it will
loosen; turn counter clockwise it will
tighten.
7. Install a new 10" TCT blade.
Assembly is reverse order of disassembly,
reattach and tighten all hardware(See Figure 8).
8
1
2
Spindle-lock
i F 7 i F . g . g
Outer
Flange
Blade
Bolt
i F 8 i F . g . g
Arrow
Fig. 5
Fig. 6 Fig. 6
Inner
Flange
Blade