Maintenance - Tool Shop 240-2081 Operator's Manual

OPERATING PROCEDURES
MODES OF USE
C
M
miter lock knob( 10 on page 4).
Move the table rotation to the left or right up to 45° left & 45° right.
uickly locate 0°, 15°, 22.5°, 30° and 45° left or right by the detent clicks at these
angle settings.
Tighten the miter lock knob at the desired angle.
B
C
At extreme positions, the hold-down clamp should be moved to the right
NOTE:
side of the table to prevent interference from the movement of the cutting head.
Always check, before making the cut, if there is any potential interference from the
clamp or any other part of the machine.

MAINTENANCE

NOTE
ven though the angles are marked on the machine, it is always a good
idea to check them by making a trial cut. See Aligning Miter and Bevel, be
low.
soap and a damp (not wet) cloth.
REMEMBER
Before use, release the head lock button( 14 on page 4) and raise the handle.
the hold-down clamp at any position.
operation.
.
-
-