Fcc Notice - Sharp AQUOS CRYSTAL 2 User Manual

180
Battery Cautions
Use specified Charger only.
Non-specified equipment use may cause Internal Battery to
leak, overheat, burst or ignite, and may cause Charger to
overheat, ignite, malfunction, etc.
Battery is built into handset. Do not dispose of handset with
ordinary refuse; take it to a SoftBank Shop for appropriate
disposal.
Charge handset in ambient temperature 5
Battery may leak/overheat and performance may deteriorate
outside this range.
Volume Level Caution
To prevent possible hearing damage, do not listen at high
volume levels for long periods.
■Headphone Signal Level
The maximum output voltage for Music Player function,
measured in accordance with EN 50332-2, is 116 mV.
Stand-by Mark
: This symbol means the stand-by on/off.
C - 35 C; Internal
o o

FCC Notice

This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.
■FCC Information to User
This equipment has been tested and found to comply with the
limits of a Class B digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not
occur in a particular installation; if this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
1. Reorient/relocate the receiving antenna.
2. Increase the separation between the equipment and
receiver.
3. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician
for help.