ZKTeco ZKSD3 Series Installation Manual

Intelligent High Speed Dome（PTZ）IP Camera Installation Guide
Version: 1.0
Attention
► Do not connect cables when power is on!
Do not connect cables when power is on!
► All uncovered cable should be less than 5mm, to avoid exceptional device damage.
►Network cable quality will influence the communication distance. Please use repeater when exceeding network communication
distance.
Uncovered cable should be less than 5mm
► When camera is installed outside, please put it in thunder-proof place. Do not touch the camera when lightning.
► Camera working environment: Temperature -40 ℃ ～ +55 ℃, humidity 10% ～ 85%RH. When use it outside, please prepare
suitable protection cover.

Note: Please pay attention to above notices, otherwise the device can not work normally even get damaged seriously.
Chapter 1: Diagram for IP camera video surveillance
①Internal(or external) radio collectors like microphone to realize voice collection function
②External alarm input devices like detector to realize setting up defense function on spot
③External radio play devices like active loudspeaker to realize broadcast function
④External alarm output devices like alarming lamp to realize remote alarm linkage function
Based on TCP/IP network, it is convenient to manage and control terminal devices.
Date: 2011.10
► Please use AC 12V, currency no less than 2A
AC24V/2A
Please use repeater when exceeding 80m
1
Microphone Detective
Audio input Alarm input
① ②
Chapter 2: How to install IP camera
1. Make the red buckle and green buckle in dome core match with the red tab and green tab in upper cover. First insert the green
buckle to cover, and then insert the red buckle to cover, until a sound DI comes out.
2. Remove the screw cap of the fix bolt of the lower cover, connect the end of the anti-detachment wire in the upper cover to the fix
bolt of the lower cover, and tighten the screw cap.
①
3. Push the lower cover to upper cover aiming at related hole, and tighten these 2 screws.
4. Put the power cable, video cable and control cable through mounting bracket.
③
5. Tighten the upper cover with mounting bracket. If the device is installed outside, it is needed to wrap some waterproof tape in
screw thread before tightening.
6. Stick the paper template onto the wall, and drill holes according to the markings on the template..
7. Fix the bracket in wall by 4 screws.
TCP/IP
PC
Loudspeaker Warning lamp
Audio input Alarm output
③ ④
Shed-proof
wire
②
Installation screws
④
2