Thank you for purchasing A-1 Skyraider radio controlled model airplane. It’s very convenient for you to maintain this model due to the removable horizontal tail, vertical tail and main wings. This model airplane is a ton of fun due to the design, durable EPO material, servoless retracts, flaps and other fun features.
5. Make sure that the model, as well as the radio system, is in the good condition before flight. BlitzRCworks 7. Do not attempt to catch the plane by hand while the plane is flying.
Safety instruction for Li-poly batteries 01. Do not disassemble or reconstruct the battery. 02. Do not short-circuit the battery. 03. Do not use or leave the battery nearby a fire, stove or heated place. 04. Do not immerse the battery in water and do not get it wet. 05.
Assembly 1. Install the horn on 2. Install the horn on 3. Install the horns on 4. Connect the wires of rudder with screws elevator with screws aileron with screws landing gear. (PB2.0X30mm 4pcs). (PB2.0X15mm 4pcs). (PB2.0X15mm 8pcs). 5. Install the landing gear 7.
Page 7
19. Install horizontal tail 18. Connect soft steel wire the servo arm of tail landing gear. wing on the fuselage with screws (PM3.0X40mm 2pcs). 19. Install vertical tail wing on the fuselage with screws 21. Connect the controlling 20. Connect the controlling steel rod with the horn on (PM3.0X40mm 2pcs).
Preparation Prior to Flight Make sure the switch on the transmitter is in the "OFF" position. Insert the 8 AA batteries in the transmitter. Ensure that the throttle is fully closed before powering up the transmitter. Then connect the battery to the ESC of the model airplane and place the battery in its proper position. Test all joystick functions to ensure all control surfaces responds correctly.
Instructions for Flight Left stick Speed up pushing up Left stick Speed down pulling down Left stick Nose turn left moving left Left stick Nose turn right moving right Right stick Nose down/ pushing up descending Right stick Nose up/ pulling down ascending Right stick...
Throttle Troubleshooting Problem Cause Solution 1. Charge the batter y . 1. Battery is not fully charged. 2. The battery of transmitter is 2. Install a new set of batteries not sufficient 3. Please contact your local Motor does not run 3.
Page 11
The manufacturer reser ve the right to modify the specification of this product at any time without notice.
Need help?
Do you have a question about the A-1 Skyraider and is the answer not in the manual?
Questions and answers