Quick Start - Minelab gpz 7000 Getting Started Manual

Quick Start

Start detecting quickly with these
six easy steps.
When the detector is turned on for the first time,
or following a Reset All, you will be prompted to
set the language, the weight and length units,
and the time zone before the Detect page will
be displayed.
1 Turn On
Press the Power button on the
control panel. After the start up
screens, the Detect page will be
displayed.
2 Select Quick Start
The first function on the
Detect page is Quick Start.
It is highlighted by default.
Press Select to start the
Quick Start guide sequence.
3 Reset Settings
Select 'Reset Audio and Detection Settings'
when prompted to select an option.
Quick Start
4 Noise Cancel
Carry out Noise Cancel noise reduction by
following the guide sequence
5 Quick-Trak
Carry out Quick-Trak ground balancing by
following the instructions displayed on-
screen. It is very important to keep the coil
as close as possible to the ground, and to
sweep repeatedly over the same spot. The
audio will quickly become quieter.
6 Start Detecting
reset the detector and return to detecting.
Take the Field Guide included with your
GPZ 7000 when you go detecting for reference.
Read the instruction manual on CD for more
information on advanced operation of the
detector.
11
EN
If you experience any
difficulties using the
detector after changing
any settings, run the
Quick Start guide
sequence again to easily