Charging Batteries - Minelab gpz 7000 Getting Started Manual

Charging Batteries

EN
Charging Batteries
BC 10 Battery Charger
WARNING: Do not immerse the BC 10 charger in
any liquid or allow water ingress.
The BC 10 Battery Charger is supplied with
your detector and is used to recharge the
Li-Ion battery pack.
The BC 10 can be powered by the following:
• The supplied AC plug pack (100-240V AC)
• Typical 12V DC car or 24V DC truck
systems. (Using either the cigarette lighter
plug cable or direct battery connection cable
provided)
A USB connection is provided for charging
the WM 12.
Plug pack, car
charger,12/24V battery
terminal connection
Recharge the Lithium-Ion Battery Pack
1. Remove the battery pack from the
detector and place it into the charger,
ensuring that the connector pins align.
WM 12 charger
connection
10
2. Insert the plug pack, cigarette lighter or
direct connection battery cable connector
into the socket on the right hand side of
the charger.
3. Plug the other end of the cable into the
wall socket and turn on the switch, or
plug into the car cigarette lighter socket. If
using the direct battery connection cable
first attach the black negative (−) clip to
the negative (−) battery terminal, and then
the red positive (+) clip to the positive (+)
battery terminal.
1
4. Leave the battery to fully recharge.
The green indicator light will stop flashing
and remain static when the battery is fully
charged (this may take up to four hours).
2