Mitsubishi Electric HC8000D User Manual page 50

Troubleshooting (continued)
Others (continued)
Problem
Images are not 3D.
* The 3D glasses and
3D emitter are sold
separately. They are
not supplied with this
product.
The power of the
3D glasses turns off
automatically.
* The 3D glasses and
3D emitter are sold
separately. They are
not supplied with this
product.
There is something
wrong with the 3D
images.
* The 3D glasses and
3D emitter are sold
separately. They are
not supplied with this
product.
The indicator on the
3D glasses does not
light up even if the
power is turned on.
* The 3D glasses and
3D emitter are sold
separately. They are
not supplied with this
product.
Blue shades appear in
the 3D image.
If the following problem occurs after the lamp is replaced, check the following first.
Problem
The projector does not
turn on.
The STATUS indicator
blinks.
Solution
• It may need to switch the 3D mode (such as 3D setting system) of the recorder/player
when projecting 3D images with the 3D image supporting recorder/player. (For detail,
see the User Manual of the recorder/player.)
• Is the 3D mode of the projector set properly for the image?
 Set the 3D MODE of the projector (FRAME PACKING, SIDE BY SIDE, TOP AND
BOTTOM) properly for the image.
• The 3D glasses may become out of sync due to fluorescent light. Turn off the
fluorescent light.
• Is there any other 3D emitter or 3D image supporting television close to the 3D
glasses?
 The 3D glasses work by receiving signals from the 3D emitter. Check that there is
no interference of the signals from other infra-red emission section.
• Is the signal output from the 3D emitter being stopped temporarily because you
pressed the 3D SYNC PAUSE button on the remote control? (See page 26.)
• Is there any block in the communication area between the 3D emitter and the 3D
glasses? Or, is there a sticker or other such item on the infra-red reception section on
the 3D glasses?
 When the signal from the 3D emitter is interrupted, the power of the 3D glasses
automatically turns off 5 minutes after the interruption. Check that there is not any
block in the communication area between the 3D emitter and the 3D glasses.
• Depending on the 3D image status, you may feel something wrong with the 3D
images.
 Switch the 3D SYNC. setting of the projector to check whether or not the
uncomfortable feeling is disappeared.
 When the signal from the 3D emitter is interrupted, the power of the 3D glasses
automatically turns off 5 minutes after the interruption. Check that there is not any
block in the communication area between the 3D emitter and the 3D glasses.
• The 3D glasses may become out of sync due to fluorescent light. Turn off the
fluorescent light.
• Is there any other 3D emitter or 3D image supporting television close to the 3D
glasses?
 The 3D glasses work by receiving signals from the 3D emitter. Check that there is
no interference of the signals from other infra-red emission section.
• Does the battery of the 3D glasses die?
 Replace the battery with a new one if the indicator does not light up even when the
power is turned on.
• Adjust 3D F.R.C. LEVEL of the 3D menu in the IMAGE menu. (See page 25.)
• Adjust FINE 3D SYNC. of the 3D menu in the IMAGE menu. (See page 25.)
Solution
• Fit the lamp cover securely. (See pages 42 - 44.)
• Reset the lamp operating time. (See page 44.)
• Reset the lamp operating time. (See page 44.)
EN-50