Installing Flashing And Storm Collar; Air Cooled Chimney Installation - Napoleon NZ7000 Installation And Operating Instructions Manual

20
4.5

INSTALLING FLASHING AND STORM COLLAR

Remove the nails from the shingles above and to the sides of
EN
the chimney. Place the fl ashing over the chimney pipe and slide
underneath the sides and upper edge of the shingles. Ensure that
the chimney pipe is properly centered within the fl ashing, giving
a 3/4" (19.1mm) margin all around. Fasten to the roof on the top
and sides. DO NOT NAIL through the lower portion of the fl ashing.
Make weather-tight by sealing with caulking. Where possible, cover
the sides and top edges of the fl ashing with roofi ng material. Apply
waterproof caulking, provided with the fl ashing, around the chimney,
1" (25.4mm) above the top of the fl ashing and push the storm collar
down into the caulking. Insert a rain cap onto the top of the last
chimney section.
4.6

AIR COOLED CHIMNEY INSTALLATION

A. Install the base plate starter collar. Affi x using the four
screws.
B. Install air housing to the appliance and connect to liner.
C. Follow the chimney manufacturer's instructions for
installing the chimney.
NOTE: Only M&G DuraVent DuraPlus chimney
is allowed for use on this product.
Use only the DuraVent DuraPlus brand of air cooled chimney.
CHIMNEY COMPONENTS
12" (305mm) Chimney Section
24" (610mm) Chimney Section
36" (914mm) Chimney Section
15° Elbow
Flashing
Chimney Cap
Firestop / Radiation Shield
CHIMNEY COMPONENTS
Air Housing
Base Plate
W415-1277 / 08.12.15
DuraPlus
8DP-12
8DP-24
8DP-36
8DP-E15K
8DP-FF or 8DP-F6
8DP-VC
8DP-FRS
WOLF STEEL
NZAC8KT
8DP-BP
NOTE: Follow the chimney
manufacturer's instructions
for installing the chimney.
RAIN CAP
CAULKING
STORM COLLAR
FLASHING
88.1A
AIR HOUSING
AIR HOUSING
4" (102mm)
WEATHER
SEALANT
LINER