Appliance Setup; Remove Fixed Glass Assembly; Remove The Shipping Materials; Clean The Appliance - Heat & Glo Everest Owner's Manual

14 14

Appliance Setup

A. Remove Fixed Glass Assembly
See Section 14K.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
E. Place the Lava Rock
A bag of rock is shipped with this fi replace. Refer to Section
14.G for placement instructions.
F. Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports. Care
• Place dime-size pieces of Glowing Embers® just in front
• Place Mystic Embers on areas of base refractory away
• Save the remaining ember materials for use during
Figure 14.1 Placement of Embers
Heat & Glo • Everest • 750-900 Rev. W • 10/14
should be taken not to cover the lighting trail of ports
(from back to front).
of the port trail, but not on or in between the ports (see
Figure 14.1). Care should be taken so that the ports are
not covered. Failure to follow this procedure will likely
cause lighting and sooting problems.
from port holes. Use this material to give the appliance
a realistic ash bed.
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
EMBER
MATERIAL
43