Prepare The Hood - Jenn-Air JXT9030BDP Use & Care / Installation Manual

1. Using a Phillips #2 or a Robertson #2 screwdriver,
unscrew the hood from the bottom of crate. Refer to figure
to the right to locate all 4 screws. Discard these screws
and remove hood from wood pallet.
OPTION
A Pro Style backsplash is available (see page 5 for more
details). This backsplash must be installed before the hood
shell because the hood shell covers the backsplash top
mounting screws. In order to be able to install the backsplash,
make sure you have at least 18" (457 mm) clearance between
bottom of hood and range control panel or cooktop. (Refer to
instructions included with backsplash.)
2. Measure and mark a level line on wall above cooktop
location for the wood mounting strip (see illustrations
to the right and under step 2 on page 7). Use #10-2" flat
head screws (included in the parts bag) to secure the
mounting strip to the drywall. Make sure to hit the wall studs.
CAUTION: Due to the weight of this hood,
!
ensure that the wood strip is attached to all of
the available wall studs (2 studs minimum for
the 30 hood, more as hood width increases);
"
not into drywall alone.

PREPARE THE HOOD

1. Drywall
2. Wood Mounting Strip
3. Flat Head Screw
4. Wall Anchor Location
5. Outline of the Back of the Hood
6. Wall Studs
8
3
1
HR0002
4
2
7