Install The Filters - Jenn-Air JXT9030BDP Use & Care / Installation Manual

! CAUTION:
Remove protective plastic film covering
filters before installing them.
It is recommended to install side filters first and finish with
center one(s).
1) Insert upper end of filter into the hood (pull tab side).
2) Raise lower end toward the inside of hood.
3) Position rear part of filter into channel and pull.
4) Using the pull tab, pull on the upper end of filter and slide it
under the front inner retaining piece.
2
3
HD0024
Replacement filters are available.
Refer to page 12 for ordering information.
INSTALL FILTERS
1
4
HD0075
11