Related Manuals for JTS CS-8
Summary of Contents for JTS CS-8
- Page 1 59508-023-03...
- Page 2 CS-8 AUTOMATIC MICROPHONE MIXER...
-
Page 3: Table Of Contents
Important Caution Features Parts Identification Installation and Operation Internal Setup Application Specifications... -
Page 4: Important Caution
Always do not handle the power cord with wet hands. • Keep the devices away from fire and heat sources. Features The CS-8 Automatic Mixer provides great convenience to sound reinforcement installation with any size and any combination. Full feature design includes. • Daisy-chain with unlimited number of the CS-8. -
Page 5: Parts Identification
Parts Identification CS-8 AUTOMATIC MICROPHONE MIXER OUTPUT LEVEL THRESHOLD PEAK MIC 1/2 PRIORITY LEVEL 1 LEVEL 2 LEVEL 3 LEVEL 4 LEVEL 5 LEVEL 6 LEVEL 7 LEVEL 8 MIX LEVEL BYPASS LOCKOUT POWER CHANNEL ACTIVE Front panel Power switch Power ON/OFF indicator Input level controls: Adjust the sensitivity of microphone input. -
Page 6: Rear Panel
Important Caution VOLTAGE OUTPUT G N D RoHS conform MIC 2 MIC 1 MIX OUT MIC 8 MIC 7 MIC 6 MIC 5 MIC 4 MIC 3 DC 18V LINK IN LINK OUT Rear panel Power supply: Require 18VDC, 1 A Link In/Out: For the daisy-chain multiple mixer system, the signal will pass through “Link In/ Out”... - Page 7 Accessories AC/DC Adapter: Input:AC100~240V,0.48A Output:18V, 1.1A D8P-1 extension cable RM-12 Rack mount kit...
-
Page 8: Installation And Operation
Installation and Operation CS-8 Automatic mixer setup guides Turn “ Threshold/BYPASS control” at minimum threshold, immediately clockwise of the “BYPASS” setting. Set all “Priority switches” to “down” position. Turn all eight “Input level controls” fully counter-clockwise. Connect the “AC/DC Adapter” to the Automatic mixer and the outlet. - Page 9 SW 33~34 << RCA OR MIC SW 9~16 << SWITCH CONDENSER OR DYNAMIC MIC SW 1~8 << SWITCH FOR MIC / LINE SW 17~24 << MIC IN ATT (0dB,-10dB,-20dB) SW 35 SWITCH FOR MIC / LINE >> SW 25~32 << ATTENUATION (-10dB,-15dB,-20dB) Figure 1...
-
Page 10: Internal Setup
Internal Setup CS-8 Automatic Mixer has a substantial gain range, allowing it to accept a wide variety of microphones. These settings are located inside the unit. Before setting, please unplugged the power cord, and remove the two screws on each side of the unit, and then remove the top cover. -
Page 11: Application
Notice 2: One or more mixers could be changed to “BYPASS” mode without affecting automatic functions in other mixers in the entire daisy-chain system. Rack Mounting Combined with “RM-12” rack mount kit, the CS-8 Automatic Mixer could be mounted in a 1U rack space. LINE IN... -
Page 12: Specifications
Voltage Output When a microphone channel turn “on”, as indicated by a “Active channel LED indicator” on the front panel, the channel’s associated “Voltage Output” goes “high” (+4 VDC). This signal can be used by different applications, such as select video cameras. Driving One device Driving One LED (Larger power)