Motorola AP7131 Installation Manual page 30

30
• Standalone AP - Select this option to deploy this Access Point as an autonomous fat Access Point.
A Standalone AP isn't managed by a Virtual Controller AP, or adopted by a controller
NOTE
NOTE
10. Select the Country Code of the country where the Access Point is deployed. Selecting a proper country
is a critical task while configuring the Access Point, as it defines the correct channels of operation and
ensures compliance to the regulations of the selected country. This field is only available for the Typical
Setup Wizard.
11. Select Next to set the Access Point's network mode.
If wanting to adopt the Access Point to a controller or service platform,
use the controller or service platform's resident UI to connect to the
Access Point, provision its configuration and administrate the Access
Point's configuration.
If designating the Access Point as a Standalone AP, its recommended the
Access Point's UI be used exclusively to define its device configuration,
and not the CLI. The CLI provides the ability to define more than one
profile and the UI does not. Consequently, the two interfaces cannot be
used collectively to manage profiles without an administrator
encountering problems.
AP7131 Series Access Point
.