Motorola AP7131 Installation Manual page 20

20
5. Create a light pipe path hole in the target position on the ceiling tile.
6. Use a drill to make a hole in the tile the approximate size of the Access Point LED light pipe.
CAUTION
7. Remove the light pipe's rubber stopper (from the Access Point) before installing the light pipe.
8. Connect the light pipe to the bottom of the Access Point. Align the tabs and rotate approximately 90
degrees. Do not over tighten.
9. Fit the light pipe into hole in the tile from its unfinished side.
10. Place the decal on the back of the badge and slide the badge onto the light pipe from the finished side of
the tile.
11. Attach the antennas to their correct connectors.
For information on the antennas available to the Access Point, see
CAUTION
12. It's recommended to attach a safety wire to the Access Point safety wire tie point or security cable (if used)
to the Access Point's lock port.
13. Align the ceiling tile into its former ceiling space.
14. Cable the Access Point using either the Power Injector solution or an approved line cord and power supply.
Care should be taken not to damage the finished surface of the ceiling
tile when creating the light pipe hole and installing the light pipe.
Ensure you are placing the antennas on the correct connectors
(depending on your single or dual-radio Access Point and frequency
used) to ensure the successful operation of the Access Point.
AP7131 Series Access Point
Antenna Options
.