Installation Of Plasma Panel To The Wall (Optional); Assembling The Speakers (Optional) - Metz 42TN92 Operating Instructions Manual

Installation Of Plasma Panel To The Wall (Optional)

1- To install the plasma panel on the wall, first of all, foot assembly should be removed.
(Figure 1). Unscrew the 4 screws (M5 x 12) that attach the foot assembly to the panel and
remove the foot assembly from the panel.
The plasma TV can be installed to the wall with or without speakers.
2- Install the wall hanger as in figure 2 to the wall with 4 anchors (M10 x 50) and 4 screws
(M7 x 60).
Decide the place on the wall where the plasma panel would be placed. Level and mark
with a pencil the 4 mounting points on the wall hanger. Drill pilot holes for the plastic an-
chors and then fix the wall hanger with 4 screws (M7 x 60).
3- Raise the plasma panel and hang it to the holes on the wall hanger from the 2 hanging
screws at the rear of the plasma panel.

Assembling The Speakers (Optional)

Turn the rear side of the plasma panel and place it on a solid surface such as a table or a
desk. Put the speakers to the left and right sides of the panel. Place the speaker holders (2
on the left speaker and 2 on the right speaker) on the holes at the plasma panel and fix one
holder with 3 screws (M3 x 12) to the speaker and the panel. Connect the speaker cables to
the speakers and the Plasma Panel.
HOLDER SPK AL PART
SCREW
3X12
SCREW
3X12
FIGURE 1
- 36 -
SCREW
3X12
SCREW M5X12
SCREW
3X12
HOLDER SPK AL PART
PDP 4210