Before Switching On Your Tv; Power Connection; Connections To The Aerial Input Socket; How To Connect Other Devices - Metz 42TN92 Operating Instructions Manual

on the screen for a long time. Please note
that this does not affect the performance of
your product."
"DO NOT LEAVE YOUR TV AT STAND-BY
OR OPERATING WHEN YOU LEAVE YOUR
HOUSE"

Before Switching On Your TV

Power Connection

IMPORTANT: The TV set is designed to op-
erate on 230V AC,
• After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.
Connections To The Aerial Input
Socket
75
VHF/UHF
REAR OF THE TV
• Connect the aerial or cable TV plug to the
Aerial input socket located at the rear of the
TV and connect the cable plug coming out
from the TV out socket located on the de-
vices (VCR, DVB-T
well.

How To Connect Other Devices

IMPORTANT: Switch off the TV before con-
necting any external device.
Sockets for external connections are at the
rear side of the TV. For connection of other
devices via Scart refer to the manuals of the
related devices.
50 Hz.
CABLE TV
etc.) to this socket as
Inserting Batteries In The Remote
Control Handset
• Remove the battery cover located on the
back of the handset by gently pulling down-
wards from the indicated part.
• Insert two AAA/LR03 or equivalent type bat-
teries inside. Place the batteries in the right
directions.
• Replace the battery cover.
NOTE: Remove the batteries from remote
control handset when it is not to be used for
a long period.Otherwise it can be damaged
due to any leakage of batteries.

Switching The TV ON/OFF

To switch the TV on:

Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-
tem. Press On/Off switch " " at the bot-
tom right side of the TV. Then the TV
switches itself to stand-by mode and the
led becomes red located on the front of
the TV.
2- To switch on the TV from stand-by mode
either:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press the " " or " " button at the bottom of
the TV or press the "-P/CH" or "P/CH+" but-
ton on the remote control, so that last mode
switched off is selected.
By either ways the TV will switch on and the
led becomes green.
- 40 -