• If the plug, power cord or appliance appear to be damaged or if any vi- sible damage or water leaks are found, do not operate the iron. In such cases have it checked by Hotpoint’s authorised staff in order to avoid any hazardous situation.
INTRODUCTION or other chemicals in the water reservoir - unless recommended by Hotpoint. Never use Welcome to Hotpoint's Garment Care. Thank contaminated water. you for purchasing our new steam generator. • Never immerse the appliance in water or any We recommend registering this product on other liquid.
• Connect Blue wire to terminal marked N or co- other chemicals in the water reservoir - unless loured Black. recommended Hotpoint. Never contaminated water or coming from driers, If a 13 amp plug (BS 1363) is used it must be fitted accumulators or air conditioners. with a 13 amp fuse, either in the plug or adaptor or at the distribution board.
They will disappear in a few minutes. other chemicals in the water reservoir - unless Ironing without steam (C) recommended Hotpoint. Never contaminated water. Set the ON/OFF knob (15) to the position (= no steam).
Ironing with steam (D) Eco function (G) Your generator is equipped with an Eco function that Make sure that the water level in the reservoir is allows energy savings of energy and water compared higher than 1/4. to normal consumption in terms of maximum steam Set the ON/OFF knob in position.
Page 11
garments press the steam button for at least one In order to keep the soleplate perfectly minute to eject any residues or particles that smooth and polished, avoid any contact with metal objects and do not iron sharp objects could stain the fabrics. such as buttons, studs and hinges - they may scratch the plate.
As part of Hotpoint’s continued commitment to helping the environment, tled, or otherwise interfered with by any person not authorised Hotpoint reserves the right to use quality, recycled components to keep by us. down customer costs and minimise material wastage.
TROUBLESHOOTING Problem Possible causes / Solutions The soleplate stays cold and • The plug was not inserted or is not making contact. does not warm up. • Make sure the temperature is not set to Min. • The temperature indicator light is on. This shows that the iron is The temperature indicator light goes on and off.
Page 15
• The water reservoir needs filling. The no-water indicator light • The water reservoir was not fitted correctly. Place the water reservoir is on. in the relevant housing until it clicks into place. • The Steam Ready indicator light turns on to show that the steam generator has reached the desired steam settings. When you use The Steam Ready indicator light turns on and off.
Page 16
Indesit Company UK Ltd Morley Way, Peterborough PE2 9JB www.indesitcompany.com...